Snowmobile World banner

Rear Suspension Rails

794 views 6 replies 3 participants last post by  Downriver Thunder 
I just finished installing the suspension from a 2000 zl550 int a '99 Jag 340 chasis. The only thing I had to do was drill new holes in the rear mounting plates to accomodate the position of the tsl. On mine the tsl arms were angled toward the front of the sled and the holes I drilled were already predrilled through the mounting plate on the inside of the tunnel. They were about 2 inches forward of the factory jag holes and slightly lower. The important thing is to get the measurements correct. If they are both ETT tunnels the front holes should be the same. Mine were.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top