Snowmobile World banner

1 - 1 of 1 Posts

·
Registered
Joined
·
283 Posts
Discussion Starter #1
I'm about to put  a '92 Exciter II 570 back together and I have a small question about piston-2-wall clearance.

I'm on my original piston size as of yet, but due to some wear, I have 0.008" of clearance between my cylinder and piston.  

Does this seem to be OK, or should I investigate the next piston size?  I figure 0.008" is not too bad, but does anybody here consider that loose?  What is the service limit?  I've heard 0.007" and 0.009", but I'm not sure.

Thanks!
 
1 - 1 of 1 Posts
Top