Snowmobile World banner

1 - 4 of 4 Posts

·
Registered
Joined
·
83 Posts
Discussion Starter #1
My buddy sandblasted my pipes and box and didn't plug the holes like I told him to.  Lots of sand or bead blast in them and need to know a couple of things.  Will the sand get sucked into my zrt 600 engine by back pressure or whatever.  Should I run water thru the pipes and the box to get out what I couln't shake out. Please help with any suggestions other than buying a new box.

Thanks!
 

·
Registered
Joined
·
3,910 Posts
Try to shake what you can out.  Try compressed air.  Then run it.  Dont use water.  Run it fast to try to blow it right out.  I dont think you will have a problem.
 

·
Registered
Joined
·
476 Posts
I don't know, I think I would just take them to one of those car washs with the hot water/soup high pressure wand type thing and give them a good shot. Just my .02 !

   -Auggie-
 

·
Registered
Joined
·
1,106 Posts
Just stick the garden hose(presure washer) in the pipe and flush it out the best you can then blow out with air and let dry.
 
1 - 4 of 4 Posts
Top