Snowmobile World banner
1 - 12 of 12 Posts

·
Registered
Joined
·
980 Posts
Discussion Starter · #2 ·
Crap, looks kit the kit won't fit..........wish I hadn't bought this POS,should have bought a 583-600 I guess. What CAN be done with this???
 

·
Premium Member
Joined
·
2,455 Posts
I use the Boivan ETS kit as well. It definitely helps the skid "couple" but you will probably have to go to a lighter spring as suggested. With the ETS you will eliminate the "bucking" but it will be firmer.
 

·
Registered
Joined
·
49 Posts
Mmmm. Not really familiar with the smaller sleds. I see. That's kinda hokey, that they didn't put ACM on it, but the pics sure do show it's not there. Suppose there are other differences, as well. I'd still think about trying some lighter springs, though. Good luck.
 

·
Registered
Joined
·
6 Posts
Belleville, I have the same problem. Bought my wife a 01 mxz 500fan. The sled can only handle about 150lbs on it. Any more than that, and it fades out bad. Wifey not happy with it at all. Have been surfing hard to find a better set-up for the sled.If you come across any aftermarket products let others know.
 

·
Registered
Joined
·
145 Posts
There is a standard and high perf. sc-10. ETS kit won't fit standard. Found this out the hard way also. MITTZ500 try going up to stiffer rear springs. Look at racing manual for next size larger p/n..
 
 

·
Registered
Joined
·
4,316 Posts
Belleville...check your mail
 
1 - 12 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top