Snowmobile World banner

1 - 2 of 2 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter #1
Where do you take the measurements when setting the toe out I was told 1/4 inch toe out for a 2002 summit700. Someone told me to put a straight edge on each ski and do the measurement at the very tip and very rear of the ski. If there are any sites this explain this let me know.
thanks:)

 

·
Registered
Joined
·
11,658 Posts
skidooski,
 nice polish name.
get a straight edge minimum 6' long, a friend uses a 6' level and i have an 8' piece of lexan the lexan is 4" wide. i just lay the lexan longside the track and measure to the ski it is closest to for 1/4" toe out you measure 1/8" on the ski and stay on the staight part of the ski. you should have a bungie cord on the ski tips not a real short one and make it a tight stretch. then when you have the side you started on finished measure from that ski to the other ski instead of moving the straight edge over to the other side. remember now have the 1/4 inch toe out on the skies.
 
1 - 2 of 2 Posts
Top