Snowmobile World banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,130 Posts
Discussion Starter #1
Anyone got any clutch tools they might part with and how much?

Im looking for a spanner wrench for pulling primary

possibly spring compressors and pullers for a 01 MXZ 800 and a 97 Formula 3.
 

·
Registered
Joined
·
720 Posts
make your own? by spannner I assume you are talking about the tool that holds the clutch while you remove/install the crank bolt? I use a hunk of pvc pipe that has a small rope trheaded through a hole in one end, I tie it through the sheave holes or slots. My spring compresser is just some 1/2"all- thread with a couple nuts and big washers, washers and non-used treads are duct tapes for scratch free padding. Your 800 doesn't need a puller if you are just tuning or cleaning, you just take the bolt out and pull the outer 1/2. Not sure about the form3? You will want some of the button retainer clips though.
 

·
Registered
Joined
·
1,130 Posts
Discussion Starter #3
Yes Id like a spanner wrench the one that holds the clutch while you pull the bolt.
I could get by without a puller.
I probably could make a spring compressor as well.
I would like a spanner though, Ski Doo wants $40 and HPE wants $20.
 
1 - 3 of 3 Posts
Top