There was a post a while back concerning the use of the sled pro tool on the zx chassis. It was brought up that a spacer is needed to properly use the tool with RER. Have emailed sled pro to send me the spacer, and they replied that they would. In the mean time, I was wondering if someone had the measurement for that thickness, and is that from the tool to the spacers Doo has on the shaft to begin with. Looked at my belt last night, Center to center is fine with tool but offset is unknown, and pulled a serious piece of cord of the side of the belt. Thanks in advance.
Sled pro tool
Join the discussion
Recommended Reading
-
1970 Ski-Doo primary clutch rpm engagement
SKI-DOOI have an early 1970s Bombardier Ski-Doo single cylinder. I need to lower the primary clutch engagement rpm. What spring and weights would make it possible to lower the engagement of the primary clutch. Thanks for any knowledge you can send my way... Chevysteve.- 0
- 63
-
Chevysteve · updated
-
My new to me sled 2019 900T Renegade
SKI-DOOI wasn't interested in a new sled. Was satisfied with my 16 4-Tech 1200 Renegade and my 17 900 ACE Renegade. Dealer talked me into trying his personnal 19 900T Renegade with a chip and reflash. Claims it puts out 190 hp. Besides being quick,and fast it doesn't lag and handled well. So I...- 0
- 147
-
SnoKing · updated
-
Do i have battery in my skidoo?
SKI-DOOHello My snowmobile is skidoo Formula MX XTC, model year 1995. My skidoo front light work poorly (only 3 volts given) and i was wondering where is the battery located? Or does this skidoo have battery at all? Engine is rotax 467. Anyway there is something wrong with electrics.- 0
- 154
-
Ski doo engine revs drop at 55 mph
SKI-DOOI ride a 2001 ski doo touring 500fan, and over the past year have spent a lot of time fixing issues with it (it was sitting unprotected in a backyard for 5 years). I cleaned the carbs, fixed some electrical contact issues, and redid much of the fuel system. It used to bog down when I went past...- 0
- 130
-
2002 skidoo 800 summit highmark brake lockup
SKI-DOOFirst time for the season the brakes lockup and got hot. and continued to do it all day. So replaced the caliper and dot 4 brake fluid cleaned reservoir and tried brakes seemed to work fine. Go out again brake lockup. Can my rotor be warped causing this brake up? Thanks in advance- 0
- 187
Join now to ask and comment!