Snowmobile World banner

1 - 11 of 11 Posts

·
Registered
Joined
·
443 Posts
Discussion Starter #1
can you get 7/8" sno-x straight handlebars?
 

·
journeyman sled/motorhead
Joined
·
4,440 Posts
if you want and cannot find. drop me a pm with the specs and we can bend/make you some from chromoly.
 

·
Registered
Joined
·
1,558 Posts
they wont work on your sled because you do not have a split throttle, the throttle wont make the bend on the bars so unless you buy a new split thorttle block it wont work, as the the bars ill have a pair as soon as i take them of my sled and put on fly bars.
 

·
Registered
Joined
·
1,244 Posts
straight 440 bars can be made to work with your controls. here's how i worked it over-

cut off the 45 angle on the right hand side and your controls will then slide over the bars. then take a plastic 45 that bolts onto the end of the bar and that's all u need. i used parts from an 03-07 rev 440 race sled to do this conversion on my consumer rev 600sdi. worked great, but parts arent cheap!!
 

·
Registered
Joined
·
443 Posts
Discussion Starter #5
lol i think i will stick with bent bars then
 

·
Registered
Joined
·
1,558 Posts
you can buy lots of bar without it to so you can look for that to but you can take those off, they just add strength
 

·
Registered
Joined
·
304 Posts
7/8 is a standard bar size. his controls should work fine!
 

·
Registered
Joined
·
1,558 Posts
the problem with the controls Rad is only on teh sno x bars. the throttle doesnt make the curve at the ends.
 

·
journeyman sled/motorhead
Joined
·
4,440 Posts
use of the throttle block off a cat should cure that problem.
 
1 - 11 of 11 Posts
Top