Snowmobile World banner

1 - 5 of 5 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
I bought a low profile (.540) track for my mxz 7 to run on ice. I now need the best stud and pattern for it. The track is the 9811 by Camoplast and the stud that I am considering is the 1.00 " Woody's 30 degree steel Eliminator or the 1.00" steel chisel. What do you more experienced racers think of my selection? Is 1" too much stud for a .540" track?
I'll appreciate all your feedback.
 

·
Registered
Joined
·
6 Posts
Discussion Starter #3
Hey Bill thanks for the reply. I have seen guys running clutching and engine mods that were done or recommended by you -Good Work. Wish you were closer to Maine so that you could do some wrenching on mine.

What length chisel should I get : .920", 1", or 1.060"?
 
1 - 5 of 5 Posts
Top