Snowmobile World banner

1 - 4 of 4 Posts

·
Registered
Joined
·
660 Posts
Discussion Starter #1
As many of you are aware, I have installed the Tempa Flow II this summer and have reported good tunability during a few test runs on the grass.

But last night was the first good snow that I could start performing 1/4 mile jetting test with piston wash.

What an amazing product!

Very sensitive and repeatable!

Did a few runs and tweaked jetting with a standard screwdriver!

Hands down, worth the money spent !

P.S. it was +30F outside and the sled ran like it was -30F
 

·
Registered
Joined
·
3,107 Posts
Good to hear madhead, as mine should be arriving today. Haven't heard one bad thing about this product.
 

·
Registered
Joined
·
660 Posts
Discussion Starter #4
Sled was a XCR 600 triple/triple

Was not difficult at all,

Sled has 3 X VM 38 roundies, drilled MAG side carb for suction fitting

Got rid of all the supplied hoses because they were very low grade. Installed top quality stainless braided hoses. Cost to upgrade hoses was about 10 bucks. But I'm sure they wont fail.

Vented Tempa Flow to airbox.

Best performance for the money.
 
1 - 4 of 4 Posts
Top