Snowmobile World banner

1 - 4 of 4 Posts

·
Registered
Joined
·
310 Posts
Discussion Starter · #1 ·
Does anyone know what the torque requirements are for the TRA clutch on a 2001 mxz 600?? both the primary and secondary clutches.
 

·
Registered
Joined
·
120 Posts
torque the secondary to 16 foot pounds and dont forget to put Locktite on it.
Then you will torque the primary to 76 foot pounds, put on a belt, start up the sled. Run the sled up to about 6000rpm's(with the track off the ground) then let it stop. Do this four or five times, then shut the sled off and retorque the secondary to 76 foot pounds again.

That is it my friend! :D
 

·
Registered
Joined
·
310 Posts
Discussion Starter · #3 ·
thnx!! now i gotta figure out how to use my torque wrench.......
 
1 - 4 of 4 Posts
Top