Track lug size?

1870 Views 2 Replies 3 Participants Last post by xc 600, Feb 16, 2002

RTCAT

Discussion Starter · Feb 11, 2002

I have a 91 Indy 500 that will eventually need a new track. I can get a good deal on 1.25 track but I'm wondering if it will fit without any clearance problems, or do I need smaller lugs? Thanks in advance.

Save

1 - 3 of 3 Posts

svanwormer

· #2 · Feb 14, 2002

If you don't run any studs, you shouldn't have any problems at all. If you want to run studs, you could have a big problem. The studs would hit the front heat exchanger in the tunnel. You have one of those don't you?

Save

xc 600

· #3 · Feb 16, 2002

I had a 90 indy 500 which I put a 1" full block track on it did touch the top of the tunnel once in a while so i drilled the holes out lower in the front of the tunnel two holes and dropped the rear bolts to the bracket that hugh under the tunnel in the rear. Worked excellent after that no more rubbing noise also had to keep the track tighter due to the sprokets ratchiting on the front drive shaft and slipping on the track.

See less See more

Save

1 - 3 of 3 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month