Snowmobile World banner

1 - 3 of 3 Posts

·
Registered
Joined
·
57 Posts
Discussion Starter #1
Gentleman,

I got my sled back saturday from the dealer.  He replaced my bad drive shaft bearing under Cat's extended warranty.

While removing/cleaning the exhaust valves, I noticed i've got some exhaust blow-by occuring where the pipe meets the cylinder on two of the pipes.  

What is a good brand/model of exhaust gasket sealer (I'm thinking the stuff in the tube like RTV silicone) to use when I put the pipes back on?

Thanks,
David
 

·
Registered
Joined
·
144 Posts
I use Permatex Hi-Temp. You can get it in black or orange. I also use it between the manifold and pipe and the pipe and can. The Graphoil gaskets don't always seal that good. Helps keep the engine compartment clean.
 
1 - 3 of 3 Posts
Top