Snowmobile World banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
So I bought this bravo 2 years ago and recently put a engine from another bravo in it since the crank seals were gone in my old one. I’ve always mixed my gas and oil but I’d rather use the injection system. Went I went to use it I made sure all the lines were still hooked up and it looks like it is. I let it run for about 5 mins and there’s still no oil coming from the pump into the carb. Any suggestions? I know no oils coming through because I see non in the new oil line I put from the oil pump to the carb
 

·
Registered
Joined
·
4 Posts
Not sure how it looks on a Bravo, but between your primary clutch and the engine inside a cover there should be a cog on the axle, which then drives the pump. Check if it's there, maybe some earlier owner removed it to run pre-mixed?
 
1 - 2 of 2 Posts
Top