Snowmobile World banner

Ski Stance

28K views 8 replies 6 participants last post by  michahicks  
#1 ·
Curious where they take the ski stance measurement from,post to post or outside of each ski?My 99 MXZ fit in the back of my Sonoma {41"as posted on Ski-doo site} New Rev it says has a 47" stance. Just wondering if I will be able to fit it in the back or not.{99 I also had put the precision skis on .}

Jay ???
 
#4 ·
Ski stance has always been measured from out side carbide to outside carbide. The Rev's really have the same ski stance per say as any other sled if you measure from outside edge of ski to outside edge of ski. With the precision ski there is no carbide in the center. it's pushed to the outside.
 
#9 ·
I think the law, at least here in Mi., limits overall width of the sled to 48". Reason is some of the older sections of trail are only 8' wide. Trails like that would tend to get ugly(er!) with sleds any wider trying to pass in opposite directions. Point is, you should be able to fit any (stock) sled made in your P.U.